Rheem Performance XE30T06ST38U1 Use and Care Manual

Water HeatersElectric ResidentialThe purpose of this manual is twofold: one, to provide the installer with the basic directions and recommendations fo

10Installing the water heater.For increased energy efficiency, some water heaters have been supplied with a 2-3/8” section of pipe insulation.Please i

11Installation ChecklistA. Water Heater LocationB. Water SupplyC. Relief ValveD. Wiring ❑ Close to area of heated water demand. ❑ Indoors and pro

12Safety Precautions Do turn off power to water heater if it has been subjected to over heating, fire, flood, physical damage. DO NOT turn on wate

13If adjustment is necessary… Turn off the power to the water heater. Remove the jacket access panel(s) and insulation exposing the thermostat(s).

14This water heater may be equipped with status lights located on the top cavity cover. The purpose of these lights are to indicate the power and ele

15Status Light Wiring Diagram (if installed)When factory installed with the status light feature, the wiring will feature four additional wires to con

16Care and cleaning of the water heater.Draining the Water HeaterCAUTION: Shut off power to the water heater before draining water.DANGER: Before manu

17Vacation and Extended Shut-DownIf the water heater is to remain idle for an extended period of time, the power and water to the appliance should be

18Before You Call For Service…Troubleshooting Tips Save time and money! Review the chart on this page first and you may not need to call for service.P

19Replacement Parts.For 20–55 gallon models with single and double elements.Instructions For Placing a Parts OrderAddress parts orders to the distribu

2Care and CleaningDraining ... 16Maintenance ... 16Extended Shut-Down ... 17Safety InformationSafety Precautions ... 3, 4

20Cavity Insert InstructionsThe following instructions are intended for qualified service personnel ONLY, and should only be done when necessary.In or

21IF YOU NEED SERVICE1. Should you have any questions about your new water heater, or if it requires adjustment, repair, or routine maintenance, it

22Notes:

23Notes:

24Wiring DiagramsElectric Water Heaters for3 - Phase ApplicationsTherm-O-Disc Thermostats(Type 59T)For the connection of thiswater heat er to a 3-Phas

3Time/Temperature Relationship in Scalds Temperature Time To Produce a Serious Burn 120°F More than 5 minutes 125°F 1½ to 2 minutes 130°F Abou

4IMPORTANT SAFETY INFORMATION.READ ALL INSTRUCTIONS BEFORE USING.WARNING!For your safety, the information in this manual must be followed to minimize

5Installing the water heater.The location chosen for the water heater must take into consideration the following:Local Installation RegulationsThis wa

6Installing the water heater.Typical InstallationThermal ExpansionDetermine if a check valve exists in the inlet water line. Check with your local wat

7!WARNING: The pressure rating of the relief valve must not exceed 150 PSI, the maximum working pressure of the water heater as marked on the rating p

8Installing the water heater.NOTICE: This guide recommends minimum branch circuit sizing and wire size based on National Electric Code. Refer to wirin

9For increased energy efficiency, some water heaters have been supplied with two 24” sections of pipe insulation. Please install the insulation, accor