Rheem Performance XG29T06MH32U1 Use and Care Manual

AP16875-1 (01/15) The purpose of this manual is twofold: one, to provide the installer with the basic directions and recommendations for the prope

10Installing the water heaterThermal ExpansionDetermine if a check valve exists in the inlet water line. Check with your local water utility company.

11A new combination temperature and pressure relief valve, complying with the Standard for Relief Valves for Hot Water Supply Systems, ANSI Z21.22, is

12Pressure Testing the Gas Supply SystemThe water heater and its manual gas shut-off valve must be disconnected from the gas supply piping system duri

13Heat TrapFor increased energy efficiency, some water heaters have been supplied with factory installed 3/4 in. NPT heat traps in the hot outlet line

14Installation ChecklistA. Water Heater LocationB. Water SupplyC. Gas Supply ❑ Water heater securely anchored. ❑ Indoors and protected from freezin

15Lighting the water heater Before operating this water heater, be sure to read and follow the instructions on the label pictured below and all other

16Time/Temperature Relationship in Scalds Water Temperature Time To Produce a Serious Burn 120°F More than 5 minutes 125°F 11/2 to 2 minutes 130

17Water Temperature SettingMaximum water temperatures occur just after the burner has shut off. To determine the water temperature, turn on a hot wate

18Draining the Water HeaterCAUTION: Shut off gas to the water heater using the gas control knob (thermostat) or manual shut-off valve before draining

19Venting System InspectionMake certain the draft hood is fastened to the water heater top pan and roof jack vent is properly positioned and securely

2Care and CleaningDraining ... 19Maintenance ... 19Burner Inspection ... 20Extended Shut-Down ...20Safety InformationS

20Before You Call For ServiceTroubleshooting TipsSave time and money! Review the charts on the following pages first and you may not need to call for

21Problem Possible Causes What To DoRumbling noise Scale and sediment  Drain the water heater to remove scale and sediment from the tank.R

22Replacement PartsInstructions For Placing a Parts OrderAll parts orders should include: The model and serial number of the water heater from the r

23Conversion instructions—Natural Gas to LP GasIf your gas supply is LP gas, your water heater can be converted to burn LP gas as follows:WARNING: Thi

24 Remove main burner orifice. Replace main burner natural gas orifice with the Red colored main burner orifice (stamped LP) supplied in the bag. Re

25Conversion instructions—LP Gas to Natural GasYour water heater was factory pre-set to burn natural gas but may have been converted to burn LP gas. I

26 Remove LP burner orifice. Replace Red marked LP gas burner orifice with the main burner orifice stamped NG supplied in the bag. Remove the compr

27NOTES:

28IF YOU NEED SERVICE1. Should you have any questions about your new water heater, or if it requires adjustment, repair, or routine maintenance, it i

3Be sure to read and understand the entire Use and Care Manual before attempting to install or operate this water heater. It may save you time and mon

4The chart shown above may be used as a guide in determining the proper water temperature for your home.DANGER: Households with small children, disabl

5LP and Natural gas have an odorant added to aid in detecting a gas leak. Some people may not physically be able to smell or recognize this odorant. I

6IMPORTANT SAFETY INFORMATIONREAD ALL INSTRUCTIONS BEFORE USINGWARNING!For your safety, the information in this manual must be followed to minimize th

7Installing the water heaterThe installation of this water heater must be in accordance with the Manufactured Home Construction and Safety Standard (T

8Installing the water heaterInstallation Methods Inspect shipment. — Inspect the water heater for possible shipping damage. Placement of water heat

9ROOF JACK — This water heater is certified for use with one of the following:AP12119B, AP12118B, AP12118C, AP12118D.Additional information on other R